AdelWiggins W900 Series Flexible Connector Installation |
|
|
|
After ferrules have been attached to tubes by swaging or welding,
installation is made as follows:
-
Install "O" Ring seal on each ferrule (lubricate before installing).
-
Install body on one ferrule.
-
Pull body back over other ferrule.
-
Install clamp assembly on body.
-
Engage latch assembly.
-
Close into locked position.
Note: Ferrules are permanently attached to the tube by either welding or swaging.
For complete information on swaging, see Adel Wiggins Installation Manual WIM-lll.
Downloadable PDF
|